spray bottle with water and 1 drop dish detergent
hard plastic squeegee or credit card
glass cleaner and clean towel
tape measure and marker
Your decal kit consists of
a white backing paper, the etched look vinyl decal, and an off
white transfer tape.
1. clean glass and hold
decals up to glass check size and make alignment marks if
2. Place decal face down
with white paper up and carefully peel back top layer of backing
paper so as not to lift decal from tape.
3. Spray glass and
adhesive side of decal with water bottle.
4. Line up and apply
adhesive side of decal to glass.
5. Starting in the center,
press firmly with squeegee and work the water out towards the
top, sides and bottom. Trim around edges if necessary. Examine
opposite side for water bubbles and squeegee to edges.
6. Allow to dry 24-36
hours then remove transfer tape by pulling down towards floor.
Etched look glass vinyl decals are a durable, exterior quality, adhesive backed vinyl with the look of frosted etched glass. Once applied, you will see only the etched design with no clear vinyl
in the background.